INTELI • TOUCH 2 © OPERATION - POWER

The POWER switch is normally left in the on position. Always turn the power off during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs.

POWER must be left on to retain a previously set fan speed or light level.

 

INTELI • TOUCH 2 © OPERATION - SPEED CONTROL

There are six individual speed settings for the fan; each speed is indicated by an audible tone of increasing pitch.

To select the desired fan speed:

1. With fan off, press and hold the button labeled . The fan blades will start rotating at the slowest speed, and will increase in steps.

2. Release the button when the desired speed is reached.

The fan speed is now in memory and will automatically come on at the same speed each time the button is used. To maintain this level of speed, turn the fan on by pressing less than one second. To lower speed, turn fan off, then on by pressing and holding the button until the desired speed is reached. When the fan is on, you may increase the speed by pressing and holding the button until the desired speed is reached, then release it.

 


FAN CONTROL ON - OFF
A momentary press of the FAN buttonTO CHANGE SPEED Press and hold FAN button longer than one second

INTELI • TOUCH 2 © OPERATION - SPEED CONTROL
The direction of airflow can be changed from downward to upward or from upward to downward.

To reverse the airflow:

1. Make sure the is on and blades are turning.
2. Press the button.

 


Note: A four-toned signal indicates the command was accepted by the fan. A few seconds later the fan will slow to a stop and then reverse direction.

 

Inteli - Touch 2 Operation - CONTINUED



P. 1




   

To Find a Service Center Near You
Call Toll Free: 1-888-227-2178